Re: Sending Bank and Program changes

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Rod on August 28, 2000 at 18:52:16:

In Reply to: Sending Bank and Program changes posted by Bob on August 28, 2000 at 12:18:19:


Check something like the midi mapper from midi solutions

http://www.midisolutions.com/

I've never looked at it in depth, but it might do what you need.

A more expensive solution is a midi patchbay which lets you modify the signals, like the digital music mx-8. I've seen used ones at ebay.

www.voodoolab.com

Hope this helps,
Rod

: I am usind the QS6.1 as the master controller in a live rig. One of the units I'm sending to is a Korg N5.When a Mix is called up the Bank change message puts it into the XG banks. The MSB for Korg banks is apparently different than for other units as all of them respond as they should,ie; user bank or preset 1,2,3 are called up etc.But there is no way to get the Korg to go to it's User Combi or program banks.According to Alesis, there is no way to separate the Bank and Program send data(turn one or the other off). I'd like to send the Korg Program change data only.The value of controller "0" is not editable either. Bummer! Any ideas would be greatly appreciated.




Follow Ups: