I think I found it!!

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Albert on September 19, 2000 at 19:04:24:

In Reply to: Problem with playing sequences from RAM card in QSR posted by Albert on September 19, 2000 at 01:05:03:


Thanks for the response, Bill. You mentioned that there was a check box somewhere in Soundbridge that would enable the QSR to control other devices. So I scoured the help file and found out that after you compile the project, you double click on your sequence(s) (or go to PROJECT>SEQUENCE INFO) and check the SEQUENCE DATA VIA OUT PORT box. Help says this about it:

---------------
· Sequence Data via Out Port: This is a check box that determines how the MIDI OUT jack of the target device handles the sequence data for this file. When it is checked, two things happen:

· The sequence data on the card plays back directly from the MIDI OUT jack, bypassing the QS synth itself.

· During playback, the QS synth’s own keyboard stops sending MIDI messages.

This setting is useful, for example, if you want your card sequence to control your MIDI network, while you play along from your QS synth’s keyboard.

When this setting is not checked, then the reverse happens: the card sequence drives only your QS synth, and nothing else, while what you play on the keyboard is transmitted through the MIDI OUT port to the rest of your MIDI network.
-------------------

This is worded kinda weird so I don't know if checking the box will make the sequence control the QSR and other devices but I'm gonna try it later.

Thanks again!




Follow Ups: