Re: How do you set a Midi file to a certain patch?

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by David Moore on December 27, 2000 at 23:12:10:

In Reply to: How do you set a Midi file to a certain patch? posted by Gregory on December 24, 2000 at 16:20:12:

: When creating a Midi File in Cubase, how do you set it so that the Midi file will control the synth and cause it to go to certain patches? Thanks.

You should be able to enter the patch change message into cubase directly. Leave a bar at the beginning of
your piece just for patch changes. You can also record patch changes from your synth (
make sure you have turned transmission of patch changes on in the global config).

I know the QS8 will do this as I have done it, but I don't use cubase so I cannot tell you how
to do it in there. There ought to be a patch map of your synth as part of the program. If not,
you should be able to find patch map files on the net somewhere, assuming cubase
supports same.

Follow Ups: