Is there a manual out there about doing a bit more complex programming like this? Sounds like your QS6 book had a bit, my QS8 book only has basics

Is there a manual out there about doing a bit more complex programming like this? Sounds like your QS6 book had a bit, my QS8 book only has basics - what does what -nt-

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Eric on February 17, 2001 at 20:25:26:

In Reply to: Re: How to wah and stuff like that... posted by Rod on February 17, 2001 at 03:24:24:

: I'm not familiar with Derek's stuff in Dream theater (more familiar with the later stuff with Jordan), but typically to simulate the synth wah effect you usually apply an LFO to the resonance of a filter.

: Since the filters are non-resonant, you're out of luck ;-). My qs6 manual says you can apply the LFO to the cutoff of the LPF to get a wah effect, but all you get is the typical 80's synth filter sweep.

: I can disaggree that the qs series is aimed at vintage moogy sounds... I think the filters aren't that great. Adequate, but it's no VA (virtual analog)

Follow Ups:

Sort of, but it's trial and error basically Rod 2/20/2001 (1)
- Pretty much all I've done, besides reading the QS manual, is experimentation, and it's worked fine, I just wonder whether there's easier and better ways to do what I'm doing, if I've missed anything -nt- Eric (Shattre) 2/21/2001 (0)