Re: ADAT Output Problems...the last of my updates
[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]
Posted by Rod on September 29, 2001 at 04:01:40:
In Reply to: Re: ADAT Output Problems...the last of my updates posted by Mark Bonnington on September 29, 2001 at 03:07:50:
I don't think it's clipping. Sounds like a clock issue. Unless you tell them to follow a common clock they will fall out of synch even if they are following the same sample rate.
You have to make sure on the q20 you have selected something like "external" and "digital" as your "clock" source & "input" source, respectively.
On the qs, your Sync source should be set to "internal." That should eliminate the clicks and pops.
I'm not too familiar with the ADAT on these two machines, but this was the solution for a similar problem between an ADAT machine and a digi001.
- Re: ADAT Output Problems...the last of my updates Mark Bonnington 9/29/2001 (2)