Re: ADAT Output Problems

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by David Moore on September 30, 2001 at 21:21:29:

In Reply to: Re: ADAT Output Problems posted by Mark Bonnington on September 29, 2001 at 15:07:07:

: The clock speeds are set to output on the QS8.1, and set to input on the Q20. Is it possible that a bad line is causing the clicks?

You have not mentioned setting the free running clock speed of the M20. The
sync is a phase lock loop and if the free running freequency is 48 while the data being
sent is only 44.1, you can expect that you will lose synch every so often and this will
result in clicking. I know this happens with my Core 2 card if I get the free running
frequency wrong even though its synching up to the input.

Follow Ups: