Re: Program sounds different in MIX mode

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by ReckRec on August 19, 2002 at 22:04:44:

In Reply to: Re: Program sounds different in MIX mode posted by Chris on August 19, 2002 at 12:08:40:


Chris,

Thanks for the reply. I haven't tried it yet but that sure sounds like the answer. I'll give it a shot and let you know. Thanks again.

Reck

: In MIX mode, all programs share the effects settings of a single specified program. If you want the patch to sound the same as it does in PROGRAM mode, you'll have to specify that channel as the effects channel. Press Edit, 80 (effects), page 2 to change it. Change page 1 to ON if you want the effects to change when you change the program on that channel. Be aware that sound will cut out when the program on that channel (and only that channel) is changed, due to the effects configuration change. Kind of sucks, since you may want your dist bass to have the distortion, but not the other programs in your mix. To remedy that, you'll have to investigate the configuration (and maybe edit it) of the patch whose effects you are using, then taylor all the other programs effects insertion routing to get around the effects you don't want on them. Or, in MIX editing, kill the effects for those programs altogether. A bit cumbersome, don't you think?

: Chris
: : On my QS6.1 I've found that certain programs sound different in MIX mode thatn they do in program mode, specifically "Dist Bass", preset 2, 049. Has anyone else had this problem? I fiddled with just about every edit window and even re-initialized the synth but to no avail. Any other program works just fine except for a couple bass voices (so far). Any suggestions?




Follow Ups: