Re: QS 7.1 Volume Problem

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by et on August 22, 2002 at 09:52:19:

In Reply to: Re: QS 7.1 Volume Problem posted by Alan Huband on August 21, 2002 at 21:13:14:


Well, if it isn't a hardware problem, I would scan through the global editing parameters to see if there is a output setting. You do this by pressing EDIT, then GLOBAL, then use the PAGE keys to cycle through all of the available parameters - see if anything there will help - maybe keyboard velocity scaling (page 4)? DO the preprogrammed sequences sound low as well? See manual on how to run the sequences. The manual is available at Alesis.com

: Every thing. The overall volume level is very low.

: : All patches? In mix and program mode?

: :
: : : I am new to the QS 7.1. I was putz'n around the setups and scewed up.

: : : For some reason, the output to either the main or aux outs is low. We have to drive a Roland KC-500 wide open to hear the thing (150 watts).

: : : I have done a factory reset to no avail. The headphone outs work fine, which is what we are using for shows. Too noisy for studio work.

: : : Any Clues?




Follow Ups: