Re: Issue choosing Mixes with sequencer

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by et on January 11, 2005 at 11:23:41:

In Reply to: Issue choosing Mixes with sequencer posted by cheryl on January 10, 2005 at 15:04:08:

What is your setting for keyboard mode? OUT01-OOUT16, Normal, solo?

: Want to use it with a computer software program, all hardware is hooked up correctly.
: Here's what happens:

: 1)Turn on qs6.1
: 2)Press the Page button to go to Channel 4
: ----IMMEDIATELY! there is NO sound.... so I then
: 3)press EDIT SELECT, and move the value to "Prg Enable ON"
: 4)Press Mix to exit EDIT SELECT
: 5)Sound works
: 6)Press Bank to try and go to a new bank, Sound OFF again, back to step 3

: The sound immediately turns off if the BANK button is pressed.
: HOWEVER, if I move the cursor down to channels 1 or 2... they always work, can change bank without a problem.

: RESETTING 0+3 is not a solution.

: This is driving me nuts...this is direct from page 17 of the "qs6 reference manual"

: Hopefully I'm not following the wrong steps for what I'd like to do.

: Thank you

Follow Ups: