Re: QS6.1 (2) me nothing


[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Jon on October 02, 1999 at 08:44:02:

In Reply to: Re: QS6.1 (2) me nothing posted by Dave on October 01, 1999 at 11:29:27:

: Make sure the following has been set correctly:

: On your QS6.1 - There is a switch next to the serial port connection, make sure its set to PC. Go into Global Edit and makre sure the IO setting is set for 38.4 baud.

: On your PC - Go into control pannel, double click on Multimedia, go to the DEVICES tab, click on the + sign next to Midi Devices and Instruments, click on the Alesis Serial Port Driver and go into the Properties for the driver. I think there is a settings button on the property sheet - make sure it is set to COM1 and the baud is set for 38,400 baud. Click OK. If you had to change the baud rate you may have to reboot before everything works.

: Baud rate mismatches are most often the problem. Are you running the serial driver from the CDROM or did you download it from Alesis? Both work, but the one from Alesis is a little newer than the one they ship on the CD. Let us know if this still doesnt work.

Also make sure you are also using version 3.04 of the Alesis serial driver. It can be found in the software section of this website. I have an IBM laptop and have been thru all of this before. I can almost guarantee it will not work with the driver on the CD. However, the new driver was easy to set up and works perfectly.

Jon


Follow Ups: