Re: hammond B3?

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Bob on March 13, 2000 at 02:35:26:

In Reply to: hammond B3? posted by Martin on March 12, 2000 at 11:46:23:

: Is it possible to get a hammond b3 sound out of my QS6?

You bet. I use an S4+ and get decent B3's so you should be able to as well.Some of the factory organs are pretty good, but if you don't like them they are still a good place to start editing. Try assigning different registers to the four voices, such as 8',4',2',etc. and use the sliders to control the respective volume levels by assigning controller #7 to them. This will give you a pretty cool drawbar simulation. Be sure to route all through the Leslie configuration in the effects section.

Follow Ups: