Posted by Karl on September 03, 2001 at 19:24:28:
In Reply to: how to split half the keys to aux output? posted by Jeff W on September 02, 2001 at 19:10:52:
It is easy to separate 2 sounds
1: Assign the 2 sounds you will use in a custom mix.
for example Bass on channel 2 and Piano on channel 1
2: While in [edit mix] mode set the split point under
[range] page. Simply set the range using LoLimit and HiLim.
3: under [level] page you can select the output for each channel
Karl
: Is there a way to split the keyboard so everything below middle C goes to the aux outputs and everything above goes to the main stereo outputs?
: This would help me separate my left hand bass lines from the right hand during recording. Then I could either redo the bass or apply effects/volume separate from the right hand.
: I assume this will be some sort of custom mix. I can't seem to figure out the manual... can you give me step by step instructions?
: Thanks,
: Jeff W