Posted by Tom Cantrell on September 23, 1998 at 22:29:45:
In Reply to: Setting up a mix Problems posted by Chris on September 23, 1998 at 01:24:17:
You can set any of the 16 channels of a mix to whatever voice you want by first get into mix mode by pressing mix then press the page button until you get to the channel you want, then press the number of the voice you want.
After you have the voice set, hit edit select. Next hit 90. Page through the options, and number 3 is whether the keyboard is on or off. Next hit 110. This will let you set the high and low limit of the voice. (use the value buttons or the controller A slider)
Hope this helps. If at any time you lose where your at, hit mix and start all over again.