Posted by sam on July 27, 2000 at 20:30:46:
In Reply to: Using ADAT out of QS8 posted by Greg Jones on July 27, 2000 at 15:07:02:
I use it, and it works fine. You know the sync cable should be a
75 Ohm video cable, not a 50 Ohm network cable? It's a bit suspect
that it doesn't fit solid, mine fits fine. My QS8 is set for
44K external in the global section, I assume you set the clock source
appropriately on both the QS8 and the card? And you get the same
result if the QS is the clock master and the card is slaved to
the clock on the lightpipe? Also when in doubt make sure you
have the latest soundcard drivers.
Do you get the same results at 44 and 48Khz (with both ends set
up appropriately, and maybe trying the master clock from each side
with each option?)