Posted by Mike on February 25, 2001 at 20:58:13:
I'm new to getting everything set up with my QS6
I'm using a SERIAL cable on my PC instead of MIDI in/out, had to install the alesis serial driver.
I reinitialzed my board, as I just got it, and that'll wipe out any other stuff.
I CANNOT get the Drums on Channel 10 to work with any of the PRESET PROGRAMS
it's always on "StndrdSet1"
I can switch to any other channel and use all of the DRUM PROGRAMS, and any other
QS6 sound, but on Channel 10, I'm stuck with General MIDI please Help!
I'm set up like:
**
MIX GenMIDI 00
*GM Multi
**
Then I just push "Page" to choose a channel.
I have settings as follows:
**
GLOBAL
**
KBD MODE: CH SOLO
(page 6)
General MIDI: ON
(page 7)
I/O: PC 38.4K baud
(Page 15)
Midi Out: OFF
(Page 16...................Should I have that "THRU" ?? Why please?)
(I don't have any other sound modules yet, but I'm thinking of using my Creative Wavetable
as a SAMPLER, it can store up to 32mb samples!!! High quality, as good as or better
than the QS6. I think That's when I have to use THRU correct?
**
MIX
**
MIDI INPUT: ON
(Page 1)
MIDI OUTPUT: ON
(Page 2)
KEYBOARD: OFF
(Page 3)
Thank you!