Posted by img on January 11, 2005 at 14:40:33:
In Reply to: Re: Issue choosing Mixes with sequencer posted by et on January 11, 2005 at 11:23:41:
I have it on Solo, contrary to many docs, was told that's the best way to use the keyboard in combo with virtual synths/etc.
Don't want to use General midi instruments.
Think I may have figured it out.
1)Turn on qs6.1
2)Press the Page button to go to Channel 4
IMMEDIATELY! there is NO sound.... so I then
3)press EDIT SELECT, and move the value to "Prg Enable ON"
4)Press Mix to exit EDIT SELECT
5)Sound works
***DING DING DING DING ***** ***DING DING DING DING ***** ***DING DING DING DING ***** ***DING DING DING DING *****
Here is where I tried something different
6 NEW VERSION) Instead of pressing Bank, like you SHOULD be able to do...but which causes the problem defined in the original post, instead I Pressed the **PAGE** button left or right to move OFF of *Channel 4* (just pressing PAGE L or R seems to work, but I'm still going off of it most of the time) , then just move back to Channel 4, and you can press the BANK buttons to select different sounds, you can also use the Group buttons....
7)So it seems, ANY time you need to go into EDIT SELECT mode (maybe adjust volume)...and want to go back to your mix with changes INTACT...you press MIX then press one of the PAGE buttons Left or Right....maybe it says this somewhere, but haven't seen it..or forgot after reading.
(**((())))) Please let me know if SOLO is the best option, because now I have the problem of ALL sounds working correctly, except when I choose CHANNEL 10...all sounds will work fine until I press the DRUMS selection button....the DRUMS sounds DISTORTED...all volume is fine... can't figure it out.....this is NOT as important because will using outboard drums samples...but would like to have it for quick thingys and the TEMPO tick note vs. Audio..
****!!!Thank you for taking the time to respond !!!!!!!
: What is your setting for keyboard mode? OUT01-OOUT16, Normal, solo?
: : Want to use it with a computer software program, all hardware is hooked up correctly.
: : Here's what happens:
: : 1)Turn on qs6.1
: : 2)Press the Page button to go to Channel 4
: : ----IMMEDIATELY! there is NO sound.... so I then
: : 3)press EDIT SELECT, and move the value to "Prg Enable ON"
: : 4)Press Mix to exit EDIT SELECT
: : 5)Sound works
: : 6)Press Bank to try and go to a new bank, Sound OFF again, back to step 3
: : The sound immediately turns off if the BANK button is pressed.
: : HOWEVER, if I move the cursor down to channels 1 or 2... they always work, can change bank without a problem.
: : RESETTING 0+3 is not a solution.
: : This is driving me nuts...this is direct from page 17 of the "qs6 reference manual"
: : Hopefully I'm not following the wrong steps for what I'd like to do.
: : Thank you