Re: Problem with Right Output on QS 6.1

[ Follow Ups ] [ The QuadraSynth Forum ] [ FAQ ]

Posted by Bob on October 25, 2000 at 19:17:19:

In Reply to: Problem with Right Output on QS 6.1 posted by jean on October 24, 2000 at 17:22:24:


: I am having an intermittent problem with the right output on my QS 6.1. Sometime it just doesn't seem to work. Other times, the signal is greatly diminished and there is distortion (like there's a short). I've switched cables and monitors, so I know its the board, not stuff external to the board.

: Now here's the weird part. I can eventually get the problem cleared up by cycling the board on and off several times (sometimes, many times) with all output, headphone and footpedal lines disconnected from the board. Its almost as if the QS is having problems recognizing that I am using it in stereo mode, rather than mono mode (which I sometimes use at gigs).

: I've been thinking about cracking the case and checking the output connections inside the board. But I don't know how tough a job that is.

: Any ideas out there?

First, is your QS still under warranty? If so, opening it up and fiddling around may void warranty.Take to an authorized repair center. If not, definately open the bugger up and check. It may be a simple repair you can do yourself and save some bucks. If you can't find anything I'd recommend a trip to the doc.Shouldn't take much to open up.Just undo screws, lift and separate I should think.


Follow Ups: