Posted by cheryl on January 10, 2005 at 15:04:08:
Want to use it with a computer software program, all hardware is hooked up correctly.
Here's what happens:
1)Turn on qs6.1
2)Press the Page button to go to Channel 4
----IMMEDIATELY! there is NO sound.... so I then
3)press EDIT SELECT, and move the value to "Prg Enable ON"
4)Press Mix to exit EDIT SELECT
5)Sound works
6)Press Bank to try and go to a new bank, Sound OFF again, back to step 3
The sound immediately turns off if the BANK button is pressed.
HOWEVER, if I move the cursor down to channels 1 or 2... they always work, can change bank without a problem.
RESETTING 0+3 is not a solution.
This is driving me nuts...this is direct from page 17 of the "qs6 reference manual"
Hopefully I'm not following the wrong steps for what I'd like to do.
Thank you